![]() ![]() Be advised that should you select the camera in Image Capture, you will not subsequently be able to connect using NX Tether. When a camera is connected via wireless LAN or Ethernet, the Image Capture application supplied with macOS will launch with the camera displayed in the list. ![]() The pre-release burst feature included in Z 9 firmware version 2.00 cannot be used. Camera Control Pro 2 is not optimized for dark mode in macOS 10.14 (Mojave). Close these applications before launching NX Tether. Do not launch Camera Control Pro 2 while the memory card access lamp is lit. NX Tether cannot be used with Nikon Transfer 2 or Camera Control Pro 2. Nikon Transfer 2 and Camera Control Pro 2 It supports up to five simultaneous connections but can control only one camera at a time. NX Tether can switch between multiple connected cameras. Connecting via a USB adapter could cause NX Tether’s connection to the camera to end unexpectedly. Use a USB cable that connects to the camera directly from the computer. Users of the WT‑7 can refer to the section on Camera Control Pro 2 in the supplied documentation.Ĭamera reference guides and WT‑7 documentation are available from the Nikon Download Center. Users of cameras with Ethernet connectors can refer the section on Camera Control Pro 2 in the camera Reference Guide/Reference Manual. The procedure is the same as for Nikon’s Camera Control Pro 2 computer application. You will need to connect using a host profile configured for. For more information, see the section on Camera Control Pro 2 in the camera Reference Guide.Ĭameras equipped with an Ethernet connector or attached to a WT‑7 can connect to the computer via an Ethernet cable. ![]() The Z 9 can connect to the computer wirelessly using its built-in wireless LAN transceiver. For more information, see the section on Camera Control Pro 2 in the camera Reference Manual.Ĭonnecting Wirelessly via the Camera’s Built-in Wireless LAN (Z 9 Only) The D6 can connect to the computer wirelessly via an optional WT‑6 wireless transmitter. For more information, see the section on Camera Control Pro 2 in the documentation for the WT‑7.Ĭonnecting Wirelessly via a WT‑6 Wireless Transmitter The procedure is the same as for Nikon’s Camera Control Pro 2 computer application. Nikon Camera Control Pro 2 on Vimeo Solutions Video marketing Power your marketing strategy with perfectly branded videos to drive better ROI. Turn the camera on once the cable is connected.Ĭonnecting Wirelessly via a WT‑7 Wireless TransmitterĬompatible cameras can connect to computers wirelessly using optional WT‑7 wireless transmitters. Turn the camera off and connect it to the computer using the camera’s supplied USB cable.
0 Comments
Leave a Reply. |